How to Guides
Find useful how to guides for various aspects of our products below!
Can't find what you need?
Contact us at support@Kinetic-Customs.Co.Uk
Replacing a grip
(Nighthawk, Raptor & Falcon models)
Step 1
To remove an existing grip, cut down the front and back spine of the grip until it begins to separate from the shaft. Peel apart and remove.
Step 2
Ensure the gradient at the bottom of the shaft and grip match before pushing the shaft partly into the grip by hand to start.
Step 3
Place a cloth on the top of the shaft or hammer head if your hammer has a head attached, for protection. Using a soft face mallet/hammer, drive the remaining tang down into the grip until it fully reaches the top of the tang with NO GAP, you may hear a number of clicks.
Fitting a New Head
(Nighthawk model)
Step 1
Align bolt with the threaded hole & turn to engage threads. Turn 3 times clockwise
Step 2
Seat the shaft into the head with a soft face mallet
Step 3
Tighten bolt fully with allen key & torque to 40nm
Brass Engineers Centre Punch Set Up
To aid with shipping & for protection of other products during transit, the hardened punch end of this item has been turned inside the brass body of the tool. On receipt:
1
Loosen and remove the grub screw. Flip the steel punch the correct way.
2
When replacing the grub screw, ensure the screw sits within the indented section of the steel punch.
3
Re-tighten.
